AMCC 3ware 9650SE-2LP Guide de l'utilisateur télécharger pdf (Page 235)

Controller Phy Summary page

www.3ware.com 223

Controller Phy Summary page

Figure 102. Controller Phy Summary Page

The Controller Phy Summary page shows the properties of controller phys.

The Controller Phy Summary page can be accessed in two ways.If you have a

direct-attached drive you can access this page from the

Information > Drive

Information

page by clicking the phy ID for the drive. If all drives are

connected via expanders, navigate to the

Management > Controller Settings

page. Under

Other Controller Settings click the # link for Number of

Controller Phys

Phy. The ID number assigned to the phy connection.

SAS Address. The SAS address of the phy. Phys within each wide port have

the same SAS address when they are connected to an enclosure. For directly-

connected drives, each phy has a unique SAS address.

Link Enabled. The existing link speed between the controller and the hard

drive or enclosure to which it is connected.

Link Control. Selectable field for setting the link speed between the device

and the controller. The options are 1.5 Gbps, 3.0 Gbps, and Auto. The default

is Auto. See “Changing the Phy Link Speed” on page 99.

Type. Shows the type of device connected by the phy—either SATA, SAS, or

enclosure. A type of SATA or SAS means that the connection is a direct

connection to the drive. Enclosure connections are made through an expander.

ID. The VPort address of directly-attached devices. Enclosures do not have

VPort numbers, although the drives attached to them do. To find the VPort for

a drive in an enclosure, click the ID link to go to the Drive Information page.

The drive you selected will be highlighted.

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 360 361

Pas de commentaire

AMCC 3ware 9650SE-2LP Guide de l'utilisateur Page 235